Skip to content

Bernie User Guide

The Laser

Connect and drive the machine: Laser panel, connection, devices, galvo lasers, framing, camera, Print & Cut, rotary and controller.

In this section

  • The Laser Panel

    One panel for every laser: its state, the Start button, pause and stop, framing, focus, homing and moves, read from top to bottom.

  • Connection

    The four link modes — virtual, USB, network and shared — and why a USB connection fails, with the CH340 and CP2102 drivers.

  • Device Orientation

    A small test “F” tells whether the profile's origin matches the machine; Bernie then fixes the origin corner in one click.

  • Devices

    Create your machine's profile — from the catalog, the connected laser or an .lbdev file — and adjust motion, scanning offset, Z axis and G-code.

  • Galvo Lasers

    Galvo device settings, laser source, rotary and external axis, live framing, lens calibration and cylinder correction, simulated by the virtual galvo, and JCZ boards driven directly.

  • K40 Laser (M2 Nano Board)

    A K40 CO2 laser with its stock Lihuiyu M2 Nano board, driven directly over USB: board settings, connection, framing, engraving and power at the panel knob.

  • Networked xTool

    xTool M1, P2, F1, F2 Ultra, and the D1 and S1 over Wi-Fi: the whole job goes over the network and the machine engraves it on its own, with state, pause and stop in the Laser panel.

  • Cutters and Plotters

    Vinyl cutters and pen plotters: HPGL cutters by serial port, network or USB, Silhouette Cameo and Portrait over USB, Brother ScanNCut by FCM file, with blade offset and overcut.

  • Placing and Framing

    Choose where the job starts, frame its outline on the workpiece, jog the head from the panel or the keyboard and save favorite positions.

  • No-Go Zones

    Parts of the bed where the laser never fires, or where the head never goes: clamps, stops, the rotary, the edge of the honeycomb. Jobs and framings that would enter them are refused.

  • Multiple Lasers

    A machine with several heads — diode and infrared, dual head, T0 and T1 tools — describes its heads; each layer picks its own, with its offset and power.

  • Engraving

    From Start to the end sound: checks and confirmation, overrides during the job, resuming after an interruption, checklist and job log.

  • Hour Counter and Maintenance

    Work and firing hours, jobs and distance engraved for each laser, with maintenance reminders: lens, rails and belts, a CO2’s mirrors and cooling water.

  • Camera

    See the workpiece under the design: camera alignment, material heights, lens calibration, several cameras and analysis of the engraved result.

  • Projector

    A projector above the bed shows the job’s paths on the workpiece, calibrated with four markers brought onto the corners of the bed.

  • Print & Cut

    Cut exactly around a print, run a second pass over an existing cut or resume a job, from two registration targets.

  • Center of a round workpiece

    Three points on the edge are enough to find the center and diameter of a disc, a square or a hexagon, then center the job on it.

  • Rotary

    Rollers or chuck, axis and diameters, an unrolled template to go all around the object, and correction for tapered tumblers.

  • Controller

    GRBL settings with automatic backups, axis calibration, console and macros, and the comparison of the controller with the device profile.

This manual is also built into Bernie: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Bernie, for free.

Free laser engraving and cutting software for diode, CO2, fiber and galvo lasers. Windows, Mac, Linux, iPad, iPhone and in the browser.