Skip to content

The Laser

Multiple Lasers

A machine with several heads — diode and infrared, dual head, T0 and T1 tools — describes its heads; each layer picks its own, with its offset and power.

A machine with several lasers — diode and infrared (LaserPecker LP4), dual head, modules selected by a T0/T1 tool — describes its heads in the device settings, Laser Heads section (G-code machines; not for a galvo or a K40). Preset… fills the list (diode and infrared of the LP4, tools T0 and T1); Add a Head creates one. For each:

  • Name: shown in the layers (“Infrared 1064 nm”).
  • Offset X / Y (from the second head on): position of its beam relative to the first one, in machine coordinates (mm). To engrave in the same place, the machine moves by the same amount: the design stays in place on the workpiece.
  • Commands to Select It: the G-code that switches to this head, one command per line (M3010, T1, M6 T1, G4 P1 to wait…).
  • Maximum Power (S): S value for 100% on this head; 0 keeps the device’s.

Each layer chooses its head (Head, below the mode; its sub-layers keep the same one); the material library remembers it with the settings. During the job, Bernie turns the laser off, sends the head’s commands, then engraves with its offset and power; at the end of the job the machine returns to the first head: framing and manual firing use it (put a visible head first, the diode rather than the infrared). No-go zones take the offset into account: the machine does not move through a zone the head must not enter. The LaserPecker LP4 from the catalog, and an .lbdev profile whose macros select the source (“Select … Laser”), come with their two heads. Custom G-code has {head} (name of the layer’s head). Ruida machines with a dual tube: tubes are still chosen per layer (Tubes), from the Ruida window.

This manual is also built into Bernie: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Bernie, for free.

Free laser engraving and cutting software for diode, CO2, fiber and galvo lasers. Windows, Mac, Linux, iPad, iPhone and in the browser.