Skip to content

The Laser

Projector

A projector above the bed shows the job’s paths on the workpiece, calibrated with four markers brought onto the corners of the bed.

A projector fixed above the bed shows the job’s paths on the workpiece, light on black: to place the workpiece in the right spot or check a design before engraving. View › Projector… (Mac; More menu on iPad and iPhone; View › Projector… in Bernie Studio and the desktop app).

  • Open the Projector Window (Mac, Bernie Studio, desktop app): choose the projector’s screen if it is offered — the window goes full screen on it —, otherwise move the window to the projector and make it full screen (in Bernie Studio: Full screen button or double-click). On iPad and iPhone, connect the projector (USB-C, HDMI) or choose it in Screen Mirroring (AirPlay): Bernie shows the paths on it instead of mirroring the screen.
  • Show: objects sent to the laser (in their layer’s color; a dark layer is projected in white), job frame (dashes), no-go zones (red), templates of the tool layers T1 and T2. The image follows the frontmost project, at every change.
  • Calibrate the Projector (once per device, or after moving the projector): four numbered markers are projected; bring each one onto the corner of the bed with its number — 1 back left, 2 back right, 3 front right, 4 front left — by dragging it in the preview, then with the arrows (steps of 1, 10 or 50). If a corner is not visible, bring the marker onto an engraved mark and enter its position on the bed (X, Y in mm). Reset Calibration goes back to the starting calibration. The calibration is kept for the device.
  • Paths are projected where the job will be engraved in absolute coordinates; the height of the workpiece is not corrected (a thick workpiece shifts the image slightly if the projector is not vertical).

This manual is also built into Bernie: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Bernie, for free.

Free laser engraving and cutting software for diode, CO2, fiber and galvo lasers. Windows, Mac, Linux, iPad, iPhone and in the browser.