The Laser
Controller
GRBL settings with automatic backups, axis calibration, console and macros, and the comparison of the controller with the device profile.
GRBL: Controller Settings ($$) — read, edit (a backup is made before each write), save and restore; the manufacturer settings (motor wiring and direction, inverted signals, steps per mm, homing, grblHAL extended settings) are collapsed: expanding them first shows a warning, since a mistake can stop the machine from moving or make it grind against its stops; Calibrate an Axis — corrects the steps per millimetre from a measured distance. Console: exchanges with the controller, command entry, “Show all” to also see status reports. Macros: command sequences in one click. Each can have a keyboard shortcut: ⌥⌘1 to ⌥⌘9 on Mac and iPad (edit the macros › Shortcut; Laser menu › Macros), Alt + a letter or digit, or F2 to F10, in Bernie Studio (✎ on the macro, then press the keys in the Shortcut field). A shortcut runs only one macro.
Settings compared with the profile
At each connection, Bernie compares the settings read ($$) with the device profile — maximum power ($30), laser mode ($32), travel ($130, $131), speeds ($110, $111), accelerations ($120, $121), junction deviation ($11). The Laser panel reports the differences; Show… details them: Align the Profile with the Machine copies these values into the profile, Enable Laser Mode writes $32=1. Bernie also remembers the settings of the previous connection: a setting changed since then (firmware update, other software) is reported, and Restore Previous Values writes them back (after a backup).
In Bernie Studio: Laser panel › Controller settings… — the same differences and fixes, the editable list of settings (manufacturer settings behind a warning), Save settings… and Restore settings…; the automatic backup and the reading of the previous connection are kept in the browser. Calibrate an axis… is also in the Laser panel.
This manual is also built into Bernie: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Bernie, for free.
Free laser engraving and cutting software for diode, CO2, fiber and galvo lasers. Windows, Mac, Linux, iPad, iPhone and in the browser.