Skip to content

Bernie User Guide

Share the Laser (Hub Mode)

The Mac next to the laser lets an iPad, another Mac or a browser send jobs, with a pairing code and each start confirmed on the Mac.

The Mac connected to the laser can share it with other devices on the local network (iPad, Bernie Studio): they see the laser’s state and progress, send a job, pause it or stop it.

Desktop app (Windows, Linux)

Laser connected over USB, Laser panel › Connection › Share This Laser on the Network (Hub Mode)… (after the question; off by default). The PC becomes a Bernie Link: it serves Bernie Studio to the browsers on the network (http://<PC address>:46490/, shown with the pairing code), announces itself on the network and keeps the job queue; every start is confirmed on the device that sends it, and this PC keeps control (pause, stop, removing any job from the queue). Stop Sharing gives the port back to the app. Allow Bernie on the private network if the system asks.

  • Turn on: Settings › Automation › Laser Sharing (Hub Mode) › Share Laser on Local Network (off by default). The Laser panel shows it at the top (“Shared on local network”, code and devices).
  • Pairing code: eight characters shown on the Mac, to type on the other device; it stays the same from one launch to the next. New Code removes access from devices already paired; after too many wrong codes, the code changes by itself.
  • Every start is confirmed on the Mac: a job sent (or resuming a paused job) opens a request on the Mac’s screen — device, job name, lines, extent, maximum power. Start or Refuse; nothing starts remotely. A job that goes outside the work area can’t start, as with a G-code file opened on the Mac. Pause and stop remain possible from the other device.
  • Local network only: the Mac only answers local network addresses (never from the Internet); it announces itself with Bonjour, or can be reached by its address (shown in Settings, port 46490 by default).
  • From a browser (Windows or Linux computer, tablet, Chromebook): the Mac itself serves Bernie Studio — open the address shown in Settings › Automation › Laser Sharing (“Bernie Studio: http://…”). In the Laser tab, Laser shared by “Mac”: type the code, Connect to Mac, then Send Job to Mac; the Mac confirms it on its screen. The page is not secure (http): WebGPU, the camera and the browser’s serial port are not available there; drawing stays smooth with WebGL.
  • On the other device (iPad, or another Mac without a laser): Laser panel › Laser Shared on the Network. Macs sharing their laser are listed (a click fills in the address); type the pairing code, then Connect. You see the Mac, the laser, the state and the progress. Send Job prepares the open document’s job as it would here (pre-flight check, head position read from the Mac) for the device chosen on this device — choose the same one as on the Mac — and sends it: “waiting for confirmation”, then “started” or “refused”. Withdraw Request, Pause, Request Resume (confirmed on the Mac) and Stop.

In this section

  • The Pairing Code

    The 8-character code a device enters once to use a shared laser, and where to find it: Bernie Link on a board or on Windows, a Mac in Hub mode, the desktop app.

  • Bernie Link Without a Screen

    A Raspberry Pi or an old PC next to the machine shares the laser with no Mac switched on: one-line install, pairing code, remote framing and focus.

This manual is also built into Bernie: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Bernie, for free.

Free laser engraving and cutting software for diode, CO2, fiber and galvo lasers. Windows, Mac, Linux, iPad, iPhone and in the browser.