The Laser
Engraving
From Start to the end sound: checks and confirmation, overrides during the job, resuming after an interruption, checklist and job log.
Start (at the top of the panel) runs the checks then asks for confirmation, with the pre-flight warnings — for example a layer speed beyond what the laser can do: it would cap it without saying so. During the job: Pause, resume, speed and power overrides (“During the Job” section), Stop (⌘.). Home before each job (device setting, on by default for a machine with limit switches): each job starts with $H, so it starts from a known position, even after an interrupted job or a head moved by hand (no effect when starting from the current position). After an interruption, put the preview slider where to resume and use “Start Here”. You can also save the G-code (preview › G-code) or run an existing G-code file. During a job, the Mac does not go to sleep (the iPad keeps its screen on): sleeping would cut off the sending.
- Resuming after a power cut: during a job, Bernie keeps a copy of the project and notes how far the engraving has got. If the job does not end normally (power cut, computer switched off, laser unplugged, alarm), a banner offers to resume it, at once or at the next launch. Resume… reopens the project as it was, with the preview stopped a little before the stop (the controller receives moves slightly ahead): compare with the workpiece without moving it, adjust the slider if needed, connect the laser, then Start Here; Forget removes the offer. Resuming lands right when the job starts from known positions: homing before each job, or the user origin; when starting from the current position, first bring the head back to the job’s starting point. Jobs on the virtual laser are not tracked. Bernie Studio and the desktop app do the same (copy kept by the browser), with the time slider and Start Here in the preview card.
- Checklist (Settings › Laser › Before and After Each Job; Bernie Studio: Preferences › General › Before each job): before the confirmation, a list of items to tick (material in place and focus, exhaust, air assist…), editable, one item per line; on by default. Tick before starting: “Start” stays greyed out until every item is ticked (otherwise, just a list). Also before turning on the laser: the list comes back before laser focusing and before a Ruida’s traced frame. Not on the virtual laser.
- End sound: a sound signals the end of the job (can be turned off in the same place).
- Job log (Laser › Job Log…): every job is recorded with the project, device, estimated and actual times and its outcome (finished, stopped, error); CSV export for a spreadsheet. After three finished jobs of at least one minute, the preview also shows the time based on your jobs on this device. Virtual laser jobs are not recorded. In Bernie Studio: Laser panel › Job log… (log kept in the browser).
This manual is also built into Bernie: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Bernie, for free.
Free laser engraving and cutting software for diode, CO2, fiber and galvo lasers. Windows, Mac, Linux, iPad, iPhone and in the browser.