The Laser
Networked xTool
xTool M1, P2, F1, F2 Ultra, and the D1 and S1 over Wi-Fi: the whole job goes over the network and the machine engraves it on its own, with state, pause and stop in the Laser panel.
Experimental: written from the public documentation of xTool’s protocols and tried on simulated machines, not yet on every real machine. Run a first job at low power, on a scrap piece.
xTool machines without a serial port for G-code (M1, M1 Ultra, P2, P2S, F1, F1 Lite, F1 Ultra, F2 Ultra), and the D1, D1 Pro, D1 Pro 2.0 and S1 over Wi-Fi, receive the whole job over the network and engrave it on their own (Mac, iPad, iPhone, Windows and Linux desktop app).
- Creating the device: Bernie tour or Add a Laser…, catalog machine; for a D1 or an S1, at “Your machine”, Controller: Networked xTool (Wi-Fi), or USB cable to send line by line.
- Address (Laser panel): the machine’s address on your Wi-Fi (xTool Creative Space or your router shows it); over the USB cable, the M1 answers at
201.234.3.1, the F1 and F2 at172.25.3.1. Close xTool Creative Space and xTool Studio: the machine talks to only one program at a time. - Protocol: detected on connection — D1 and D1 Pro, S1, M1 on V1 firmware (adapted G-code: laser turned on once, whole-number powers, Z axis counted from the focus height), or recent firmware (V2: encrypted link, port 28900). Choose it if detection hesitates.
- Test the link: the machine gives its name, protocol, version and state, without moving anything.
- Start…: the job’s G-code (the G-code export, adapted to the machine) is sent after confirmation and the checklist. The D1 and machines on recent firmware start right away; the S1 and M1 wait until you press the machine’s button (a safety of their firmware). The state (ready, job loaded, running with progress, paused, error) is read during the job; Pause, Resume (confirmed) and Stop.
- Virtual xTool machine (test without a machine): the job goes to an imaginary machine of the chosen protocol, which reports what it received.
- In a browser, Bernie Studio does not control these machines: export the job as G-code.
This manual is also built into Bernie: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Bernie, for free.
Free laser engraving and cutting software for diode, CO2, fiber and galvo lasers. Windows, Mac, Linux, iPad, iPhone and in the browser.