Skip to content

Files

Layered Panel

Turn a picture into a plywood panel of stacked layers: one tone per layer, a frame, cutting rules, loose pieces and a gluing order marked on each piece.

File › New Layered Panel… (iPad: “More” menu; iPhone: Project tab) turns a picture into a plywood panel made of layers glued one on top of the other: each tone of the picture becomes a layer, cut from its own sheet, with a frame; the last one is the back plate.

  1. Picture: a logo or a drawing with flat colors, or a photo (smoothed, then reduced to a few tones). Transparent parts go to the back.
  2. Panel: number of pieces (back plate included, 6 by default; at most the number of tones in the picture), width or height (the other follows the picture), plywood thickness, your laser; Swap front and back puts the dark tones in front.
  3. Cutting rules, in mm whatever the size: frame width (by default 5% of the shorter side, 5 to 10 mm), thinnest part kept, smallest loose piece, gap between pieces laid out on one sheet. What the rules remove shows in red: make the panel bigger, lower the rule, or join those parts to the layer behind.

Layers

The Assembled preview shows the finished panel; click a part to select it (a whole layer from the list). Join moves the selected parts to the layer behind (or to the furthest back of the selected ones), Delete sends them to the back; the arrows move a layer forward or back (the back plate stays at the back). Undo and Back to the start take these changes back. The Pieces to cut preview shows each piece flat: wood held by the frame, loose pieces (orange), removed parts (red).

Create the project

All on one sheet (pieces side by side; those that do not fit on the bed go to a next sheet) or One piece per page (one page per piece, see Pages); on Mac, in Bernie Studio and the desktop app, a new project, on iPad and iPhone, the empty project. Cut and Light score layers set for your laser. Loose pieces (not held by the frame) are glued onto the piece behind, where a light score line marks their place; the gluing order is marked on each frame (1 = back plate), hidden by the piece glued on it. Run a material test first.

This manual is also built into Bernie: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Bernie, for free.

Free laser engraving and cutting software for diode, CO2, fiber and galvo lasers. Windows, Mac, Linux, iPad, iPhone and in the browser.