Share the Laser (Hub Mode)
The Pairing Code
The 8-character code a device enters once to use a shared laser, and where to find it: Bernie Link on a board or on Windows, a Mac in Hub mode, the desktop app.
To connect to a shared laser, a device must enter its pairing code: 8 characters, without 0, O, 1, I or L. Without it, Bernie Link and the Mac refuse everything (laser state, job, moves), and the assistant goes no further. The device then keeps it: you only enter it once, and Forget This Code erases it (assistant, Laser panel).
Where to find it, depending on what shares the laser:
- Bernie Link on Linux, Raspberry Pi, Orange Pi: on the board, with a keyboard or over SSH, run
sudo bernie-hub --code. It is also shown at the end of the installation and in the service log (journalctl -u bernie-hub). - Bernie Link on Windows: in the Bernie Link window (
bernie-hub.exe), which must stay open. - Mac sharing its laser: Settings › Automation › Laser Sharing (Hub Mode).
- Desktop app (Windows, Linux): Laser panel › Connection, once sharing is on.
The code stays the same from one start to the next, power cuts included. After 8 wrong codes in a row, Bernie Link picks a new one: read it again the same way; devices already paired will have to enter the new one.
This manual is also built into Bernie: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Bernie, for free.
Free laser engraving and cutting software for diode, CO2, fiber and galvo lasers. Windows, Mac, Linux, iPad, iPhone and in the browser.