Drawing
Parametric Sketches
Shapes defined by constraints and dimensions instead of coordinates: change a dimension or a project parameter, such as the material thickness, and the shape recomputes.
A sketch is a shape defined by constraints and dimensions rather than by coordinates: a rectangle always three times wider than the material is thick, a notch always centered, a hole always tangent to an edge. Change a dimension, or a project parameter, and the shape recomputes. On Mac, iPad, in Bernie Studio and the desktop app (not on iPhone).
Starting
The Parametric Sketch button at the bottom of the tool palette (also in the Tools menu on Mac, the Edit menu in Bernie Studio). To resume a sketch: double-click it, or select it and use the same button. Finish Sketch (or Esc when nothing is in progress) returns to ordinary drawing: the sketch is then an object like any other (layer, moving, engraving, cutting).
| Tool | Use |
|---|---|
| Selection (V) | Click a point, a line or a circle; Shift adds; drag a rectangle to select what is inside. Drag a point, a line or the edge of a circle: the shape follows and keeps its constraints. |
| Lines (L) | Click after click; a nearly horizontal or vertical line becomes one (constraint added automatically). Click an existing point: the chain joins it and stops; double-click or Esc: finish. |
| Rectangle (R) | Two opposite corners; its sides stay horizontal and vertical. |
| Circle (C) | The center, then a point on the circle. |
| Arc (A) | The center, the start, then the end (clockwise). |
Constraints (bar above the workspace; only those that apply to the selection are enabled): coincident, horizontal, vertical, parallel, perpendicular, tangent, equal, symmetric (two points and an axis), midpoint, on element, fixed. Dimensions: distance (between two points, length of a line, from a point to a line, between two parallel lines), horizontal and vertical distances, angle, radius, diameter. A dimension takes the measured value and opens its entry: a number (units allowed: 2 cm, 1 in, 45°) or an expression (width / 2 - gap). Double-click a dimension to change it; a dimension computed by an expression shows “ƒ”.
Colors
Blue for what can still move; black for what is fully determined; orange for the selection; dashed for construction elements (Construction button: they guide the drawing and carry constraints without being engraved). The bar shows the remaining degrees of freedom, then “Fully constrained”. A constraint that conflicts with the others is refused (nothing changes); a constraint already imposed by the others is kept but flagged in orange: select its label, then Delete.
Project parameters (Parameters… button in the bar): names and their expressions, which can refer to each other (thickness = 3, width = 10 * thickness). The dimensions of every sketch, on every page, can refer to them: change the thickness and they all follow, in a single undoable action. A sketch that cannot follow (constraints that became incompatible) keeps its shape, and the window says so. Expressions: + - * / % ^, parentheses, pi, sqrt abs round floor ceil min max sin cos tan asin acos atan (angles in degrees), decimal point or comma (2,5), function values separated by ; or , (min(3; 5)).
A project with sketches is saved in a format that earlier versions of Bernie refuse to open (without damaging anything). Convert to Path turns a sketch into an ordinary path, without its constraints.
This manual is also built into Bernie: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Bernie, for free.
Free laser engraving and cutting software for diode, CO2, fiber and galvo lasers. Windows, Mac, Linux, iPad, iPhone and in the browser.